Programming a HelixNet LQ Link-Group

The HelixNet Main Station that has been designated as the Link-Master must be reachable on an IP network by all other Link-Memebers.

The HLI-ET2 module must be fitted to the HelixNet Main Station for IP connectivity.

To access the Core configuration manager (CCM), input the IP address of each device into the address field of a browser.
Once LQ and HelixNet devices have been joined to a Link-Group, they can be monitored and configured from any device within that group.
An LQ/HelixNet Link-Group supports up to three linked HelixNet Main Stations and up to three linked LQ units (a maximum of 6 devices in total).

Find details of the CCM username and password here: The Core Configuration Manager (CCM) Password

General outline: create a HelixNet/LQ Link-Group

1. Ensure the HelixNet device is set to Link-Master in the CCM of the Main Station. Navigate to Device > Linking > Link-Group Role.
1. Set Link-Group Role of LQ unit to Link-Member. Navigate to Device > Linking > Link-Group Role.
2. Input Link-Master IP address.
3. For each device to be added to the Link-Group, input the device IP into the browser’s address field to access the CCM, designate the device as Link-Member and give it the Link-Master IP address (this links the device to the group).
4. Linked devices can be seen in the Overview page.
5. Navigate to the Assignments page to create, configure and view how audio is routed throughout the system. All ports on the LQ units will now be visible and available for assignment into one or more channels.